5 car secrets that make life easier for the driver

5 car secrets that make life easier for the driver Car enthusiasts with experience are carriers of numerous life hacks that allow you to make life behind the wheel more convenient, as well as prepare for various unforeseen situations. Here are 5 such secrets. Non-freezing areas for the off-season The washer tank in the warm season is usually filled with plain water. This is much more economical than constantly pouring in a non-freeze, in addition, the latter often emits very high temperatures at high temperatures. unpleasant smell. But what if at night the temperature falls below zero, while the day is still warm? In this situation, the water may freeze, causing the tank to deform or, even worse, it may crack. In order to avoid this problem, the washer fluid is poured into barrels or cans with labels indicating the contents. That is, the bottles and cans are sealed, preventing the liquid from spilling out. Seals Prevent leakage of liquid from the washer nozzles By the way, this is not a myth, but rather a well-known fact: when using a non-freeze, it is better to seal it so that it does not get into the intake tract. The washer liquid can leak out through any sealant the manufacturer . Sealant for the windshield washer nozzles It saves money on bottle filling Of course, it is best to seal the canister with a sealant of some kind. It can be any kind of sealant, as well as silicone or oil. The main thing is not to overdo it with the amount of sealant, so that the canister can expand and fill it with water. We wrap the canister with duct tape, since plastic can breathe on the walls of the container. But it is better to use a sealant that is suitable in diameter of 12-15 cm. Aluminum foil can protect the paintwork from the effects of UV radiation For car painting, there is a procedure that all good car owners do not follow without fail. In order to avoid trouble in the form of a botched installation of a new coat of paint, you need to pay attention to the fact that the plastic itself can also be treated with a sealant. To do this, you will need a small piece of aluminum foil, with a capacity of one and a half cubic meters. This can be done in several ways. But it is worth to try it once. I am not talking about an ordinary piece of aluminum, but about a special "form factor". The foil should be covered with a thin layer of glue, so that it does not slip off when the car is running. On the sides of the foil, you need to make cuts where necessary. You can paint the surface of the body with a varnish of a similar color to the color of the paintwork. For the color of the body, it is best to use a complementary shade. Painting foams are used for car decal. They do not need to be purchased just for this reason. The procedure of painting with